Start your own FMX Show/Business!!

PRICE//SOLD!!!!!




DETAILS//
Landing ramp built with 7000lb each torsion axles and 16 ply trailer tires. It is mostly built of 2x2 square tubing and 1.5 square tubing on the wings. Center of the landing ramp is covered in 11 gauge sheet metal. Wings made with 14 gauge. I have pre rolled bottom panels for a smooth roll out for no-handed landings and any other variation. There is an 8 foot safety tongue at the top with 4 foot of it folding down for traveling. Deck is nicely angled! There is 27 feet between the transition and the run out (very bottom)! Custom built tongue that fits snug and secure. Hinges were custom fabbed to be double jointed and lay's completely flush on the top of the landing

This setup will hold a take-off ramp and bikes in rear area of landing! The face of the ramp is not pot holed out like most used fmx ramps. Spend a weekend line x'ing the top surface of the ramp and you are good! Once set up it is about 13' tall & 14.5' wide


Comes with air bag! Weighs 6500 pounds - Pull it with your 1/2 ton truck